Adaptation

Adaptation
Adaptation must be performed after the following operations:
^ After replacing the Transmission Control Module (TCM) -J217
^ After coding the Transmission Control Module -J217
^ After reprogramming (flash) the Transmission Control Module -J217

Requirement:
^ No trouble codes in the DTC memory; read DTC memory.

Adaptation for driving forward
^ Read Measured Value Block display group 010, engine at idle.





Display on VAS 5051
^ Check whether transmission fluid temperature in display field 3 is higher than 60°C. A short test drive may be necessary to reach this temperature.
^ Drive forward briefly and then brake to a stop again.
^ Check display in display field 2.
^ Display must from change "ADP. is running" to "ADP. O.K."
If the display does not come up as described:
^ Repeat start from stop and braking procedure until "ADP. O.K." is displayed.
If the specified value "ADP. O.K." is not obtained:
^ Read DTC memory =: and correct malfunction. Adapation must be performed again afterward.
^ Perform adaptation for driving in reverse.

Adaptation for driving in reverse:
^ Read Measured Value Block display group 011. engine at idle





Display on VAS 5051
^ Drive backward (in reverse) briefly and then brake to a stop again.
^ Check display in display field 2.
^ Display must from change "ADID. is running" to "ADP. O.K."
If the display does not come up as described:
^ Repeat start from stop and braking procedure until "ADP. O.K." is displayed.
If the specified value "ADP. O.K." is not obtained:
^ Read DTC memory and correct malfunction. Adapation must be performed again afterward.