Symptom Related Diagnostic Procedures

Steering system, checking for leaks
^ Start engine.
^ Turn steering wheel to stop in both directions and hold briefly.
This builds up the largest possible pressure.

Note: To avoid damage to the pump, do not allow the engine to run more then 10 seconds during the test.

In this position, the following components must be checked for leaks:
^ Seal for steering pinion at valve housing of steering gear.
^ All wire connections
^ Rack seals

Note: This test can only be performed if hose clamps for boots are easily accessible.

^ Open hose clamps for boot.
^ Slide back boot.
If fluid is visible in steering gear housing and/or in boots, steering gear must be replaced.