Roll Bar: Locations

Rollover Protection, Assembly Overview







1. Rollover protection
- Removing
- Remove rear bench seat.
- Remove rear seat backrest.
- Remove trim for ski bag.
- Close convertible top and fold convertible top compartment upward.
- Unclip clips - 3- (2x) on back panel trim - 2 -.
- Fold back panel trim - 2- aside in direction of - arrow -.

2. Luggage compartment back panel trim
3. Clips (2x)







1. Rollover bar
- Remove bolts - 2- (2x).
- Fold convertible top compartment downward.

2. Bolts (2x)







1. Rollover protection
- Actuate convertible top far enough to allow access to convertible top compartment.
- Extend rollover protection -1-.
- Unclip clips - 3- (2x) on back panel trim - 2 -.
- Fold back panel trim - 2- aside in direction of arrow.


2. Luggage compartment back panel trim
3. Clips (2x)







1. Rollover protection
- Check if and where shims are installed on rollover protection - 1 -
- Mark the points where the shims were removed.
- Remove bolts - 2- (4x).

2. Bolts (4x)







1. Rollover protection
- Press catch - 3 - and detach connector for solenoid valve - 2-.
- Pull out rollover protection -1 -.
- Installing
- If installed, install shims in same places on rollover protection -1 -.
- Retract rollover protection -1 -.
- Ensure that connector for solenoid valve - 2- engages audibly.
- Install rollover protection -1- in reverse order of removal.
- Check function of rollover protection with control element test.

2. Connector for solenoid valve
3. Release







Retracting rollover protection

CAUTION: Ensure that hands do not become trapped when retracting rollover protection.

- Press release lever -1- in direction of - arrow-.
- Retract rollover protection.