Coolant Fan -V7- (Left), Removing and Installing

Coolant Fan -V7- (left), removing and installing

Removing

Note: All cable ties opened or cut during repairs must be reinstalled at the same locations.

- Bring lock carrier into service position Coolant Fan -V7- (Left), Removing and Installing





- Disconnect electrical harness connector - arrow - on Coolant Fan Control (FC) Control Module -J293-.
- Move coolant fan wiring harness clear.





- Remove bolts - arrows - and remove fan.

Installing
Installation is performed in reverse order of removal. Note the following:

Note: During installation, reinstall all cable ties at the same locations.





- Install lock carrier with attachments. [1][2]Procedures
- Place torque support on rubber buffer for torque support and tighten bolts - arrows -.
- Install front bumper cover.
- Check headlight adjustment.

Tightening torque