Fuel Tank With Attachments - Component Overview - Up to 10.04

Fuel Tank With Attachments - Component Overview







1. Bracket
- For exhaust system
2. Carrier plate
3. Fuel line
- From fuel filter
- To engine
- Do not kink
- To disconnect, press release button on connection piece
4. Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- Do not kink
- To disconnect, press release button on connection piece
- Clipped in on fuel tank
5. Electrical harness connector
- For Fuel Tank Lock Switch F314
- Checking electrical.
6. 2 Nm
7. Heat shield
- For fuel delivery connection
8. 23 Nm
9. Overflow hose
10. Rubber cup
11. Circlip
12. Oil seal
- Replace if damaged
13. Cap
14. Ground connection
- For discharging electrostatic charge
- Installed position / check requirements
- After installing, check electrical connection of metal ring at fuel filler tube to a bare area of chassis using Ohm meter - Specified value: approx. 0 Ohm.
15. Ventilation line
16. Ventilation line
- From gravity valve to EVAP canister
- To remove, press release ring on EVAP canister
17. Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- To remove, press release ring on EVAP canister
- Clipped in on fuel tank
18. Fuel tank
19. Spreader clip
20. 23 Nm
21. Securing strap
22. Heat shield
- For fuel tank
23. 2 Nm
24. 23 Nm







Installation position of Ground (GND) connection
- Route Ground (GND) connection as shown in illustration.
- First hook Ground (GND) connection contact - 1 - into securing hole on fuel tank - 5. and then press in spacer bushing - 2-.
- Make sure connector of Ground (GND) connection - 4. fits securely at metal ring - 3 - of fuel filler tube.

CAUTION: After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using Ohm meter:

- Specification: approx. 0 Ohm.