Wind Deflector, Removing and Installing

Wind Deflector, Removing And Installing







1 - Wind deflector
- Remove front trim for convertible top storage compartment
- Remove rear panel center trim
- Remove bolts - 3 - (2x) at roll bar crossmember.
- Adjust panel fully down.

CAUTION: Remove ignition key before continuing with removal of wind deflector.

- Open left assembly cover.
- Disconnect harness connector.
- Raise panel by hand
- Remove bolts - 2 - (4x).
- Lift cover up slightly.
- Lift lining of convertible top storage compartment up slightly on left side.
- Pull wind deflector rearward first and then upward and out.
2 - Bolts (4x)
- Tightening torque 23 Nm
3 - Bolts (2x)
- Tightening torque 23 Nm