Diagnostic Mode 7: Check Results - Continuously Monitored

Diagnostic Mode 7: Check Test Results Of Components That Are Continuously Monitored

Function
This diagnostic mode indicates all stored DTCs of components and systems which are continuously monitored.

Requirement
- There must not be any DTCs stored in DTC memory, Diagnostic mode 3: Check DTC memory. Diagnostic Mode 3: Check DTC Memory

Procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Start engine and let run at idle.

NOTE:
Only if engine does not start:
- Operate starter for approx. 6 seconds. Do not switch ignition off afterward.

- Under address word 33, select "Diagnostic mode 7: Check test results of components that are continuously monitored".

The number of stored malfunctions or "0 malfunctions detected" is displayed.

- End diagnosis and switch ignition off.

- Repair stored malfunctions according to DTC table:
- SAE P0xxx-DTCs, P0010
- SAE P1xxx-DTCs, P1102
- SAE P2xxx-DTCs. P2096
- SAE P3xxx-DTCs. P3081

NOTE:
- The DTC table is sorted by SAE codes.
- "E-Gas"-relevant malfunctions are also indicated by the warning lamp for Electronic Power Control ("EPC warning lamp") in the instrument cluster.
- Erase DTC memory after repairing malfunction, diagnostic mode 4: Reset/erase diagnostic data. Diagnostic Mode 4: Reset/Erase Diagnostic Data