Drivers Side Airbag Unit, Removing and Installing

Drivers Side Airbag Unit, Removing And Installing







CAUTION: Always read updated safety regulations for repair work on airbags

1 - Steering wheel
2 - Coil connector
3 - Airbag unit

- Removing

CAUTION: Observe safety precautions when working on airbags.

- Use size T30 Torx wrench to remove airbag unit.
- Disconnect connector --.
- Set airbag unit down with impact cushion facing upward.

- Installing
- Make sure connector -- is heard to engage.
- Screw (7 Nm) on airbag unit.

CAUTION: Make sure no one is in vehicle when connecting battery.

- Switch ignition on and connect battery Ground (GND) strap.

NOTE:
- After connecting the battery, check vehicle equipment (radio, clock, electric windows)
- If the Airbag Malfunction Indicator Lamp (MIL) K75 signals a malfunction after assembling, then DTC memory must be erased and checked again using vehicle diagnostic, testing and information system VAS 5051 A scan tool.

4 - Multi-point socket head bolt, 60 Nm
- Always to be replaced
5 - Torx bolts (T 30)
- 7 Nm
6 - Torx wrench (T 30)
7 - Coil connector with slip ring