Fuel Tank With Attachments, Component Overview
Fuel tank with attachments, component overview
1. Mounting straps
2. Fuel filter
^ Note installation position
^ Installed position: arrow points in direction of flow
3. Supply line
^ Black
^ To fuel rail
^ To remove fuel filter, press release button at connection piece
4. Screw clip
^ For fuel filter
5. Vent line
^ White
^ From Evaporative Emission (EVAP) canister
^ To EVAP canister purge regulator valve -N80
6. Supply line
^ Black
^ To fuel filter
^ Attaches to connection with "V" marking at connector flange
^ Press release button on connector piece to remove from flange or from filter.
7. Return line
^ Blue
^ From fuel rail
^ Attaches to connection with "R" marking at connector flange
^ To remove connector flange, press release button on connecting piece.
8. 4-pin harness connector
9. 11 Nm
10. Cap nut -10 Nm
11. Ground (GND) connection
^ Check for tight fit of connector at metal ring of filler tube.
^ Securely tighten screw eyelet of electrical wire using cap nut item 14 .
^ After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using multimeter:
^ Specified value: approximately 0 Ohms
12. Nut -10 Nm
13. Bracket
^ For fuel filler tube
14. Sealing cap
^ With seal
15. Tensioning ring
^ Large diameter
16. Tensioning ring
^ Small diameter
17. Rubber cup
18. Vent line
^ To EVAP canister
^ Only remove together with tank protection valve and gravity valve
19. Vent line
^ White
^ From EVAP canister
^ To Evaporative Emission (EVAP) canister purge regulator valve -N80
20. Fuel tank
21. Heat shield
^ For fuel tank
22. Clamping washer
^ Removing: turn to left
^ Installing: tighten to 2 Nm
23. 26 Nm
24. 26 Nm
Fig. 1 Installation position of Ground (GND) connection
^ Route Ground (GND) connection as shown in figure.
^ Ensure connector -2- of Ground (GND) connection fits securely at metal ring -1- of fuel filler tube.
^ Disconnect Ground (GND) connection at both retaining clips (arrow).
Note: Depending on construction version, a cable binder may be implemented in place of a clip.
Test provision
^ Tighten eyelet of electrical wire -1- at chassis using cap nut -2- (10 Nm).
^ After installing, check electrical Ground connection using an ohmmeter between metal ring of fuel filler tube and chassis.
Specified value 0 Ohms
Fig. 2 Installation position of screw clip for fuel filter
^ Install screw clip (arrow) as shown.
Note: Illustration depicts fuel filter from front.