Accelerator Linkage, Servicing

Accelerator Linkage, Servicing







1. Accelerator pedal module
- with Throttle Position (TP) sensor-G79- and sender -2- for accelerator pedal position -G185-
- Throttle Position (TP) Sensors -G79- and -G185-. Throttle Position (TP) Sensor 1 -G79- and Sender -2- For Accelerator Pedal Position -G185-, Checking
2. 10 Nm
3. 6-pin harness connector
4. 10 Nm

Accelerator pedal module with Throttle Position (TP) sensors, removing and installing
- Remove driver-side storage compartment.







- Disconnect 6-pin harness connector -2-.
- Remove bolts -1- and -3-.
- Remove accelerator pedal module.

Installing
Installation is the reverse of removal, noting the following:
- In a vehicle with automatic transmission, the kickdown function must be adapted when accelerator pedal module is replaced: To do so, switch on ignition and press accelerator pedal all the way down past the kickdown point and hold in position for at least 20 seconds.
- Switch ignition off.
- Engine Control Module (ECM) now requires approx. 3 seconds to store the learned value. At this time, the ignition must not be switched on again

Tightening torque

Component Nm
Accelerator pedal module to pedal mount 10