Headlamp Igniter Module: Service and Repair

Igniter For Gas Discharge Lamps -N195-, Removing And Installing

CAUTION: High voltage: Make sure to disconnect battery Ground (GND) strap before performing work on parts of High intensity gas discharge (xenon) headlights marked with yellow high voltage symbols.

Removing
- Remove headlight.







- Remove bolts -arrows- and retaining bracket -2-.
- Remove igniter -1- for high intensity gas discharge (Xenon) from headlight housing and disconnect electrical harness connectors.

Installing
Installation is reverse of removal, paying attention to the following:
- Check seal between igniter for gas discharge lamp and headlight housing.
- Install headlight.

Tightening torque

Component Nm
Igniter for gas discharge lamp to headlight 1.2