Rear Side Window, Assembly Overview

Rear Side Window, Assembly Overview







1. Angle bracket
2. Spacer
- Note installation position. See Fig. 1.

3. Rear side window
4. Shim
- Must engage when pressed in place on retaining pins of angular bracket.

5. Window regulator
6. Combi nut
- 6 Nm

7. Motor for window regulator
- Can be removed and installed in any window regulator position.
- Upon removal, the cable tension roller must not separate from the window regulator.
- To remove unscrew bolts -8- and carefully pry off motor from tension roller.

8. Bolt
- 4.5 Nm







Fig. 1 Shim installation position

NOTE: Window assembly must be performed with window regulator installed.

- Attach the shim -2- onto the angular bracket pin -1- as shown and insert the pre-assembled window -3- into the window regulator -4-.
- Push the window -5- from the reverse side onto the pins and tighten the hex nut to 6 Nm.