Rearview Mirror - Assembly Overview

Rearview mirror - assembly overview

Special tools, testers and auxiliary items required







- Pry lever 80-200







1 - Mirror glass
- Use Pry Lever 80-200 to unclip.
- Protect mirror housing against damage using textile tape above and below.
- Press mirror lens first downward, then upward.
- to install mirror lens into guide pins and friction finger, insert into friction spring and press on.
- Apply pressure only on center of glass, wear protective gloves while doing so.
2 Mirror heating connector
3 Mirror adjusting unit
4 Adjusting motor
5 - Mirror housing
- May be removed from door without removing entire exterior rearview mirror.
6 - Electrical connection
- Clip into mirror glass on rear side.