Drive Chain Gear For Oil Pump, Removing and Installing

Drive chain gear for oil pump, removing and installing

Special tools and equipment

30-100 Press tube:

Removing
- Remove front sealing flange.





- Using claw remover -2-, remove crankshaft chain sprocket while protecting crankshaft end with appropriate washer -1-.

Installing
Installation is reverse of removal, noting the following:
- Warm chain sprocket in oven at 220°C for approximately 15 minutes.

WARNING: Wear protective gloves!





- Using pliers install chain sprocket on crankshaft end and slide onto crankshaft to stop using 30-100 press tube.