Sealing Flanges and Flywheel / Drive Plate, Removing and Installing

Sealing flanges and flywheel/drive plate, removing and installing

Note: Servicing clutch.





1. 10 Nm
2. 30 Nm
^ Self-locking
^ Always replace

3. Seal
^ For crankshaft

4. Locking bolt - 10 Nm
5. Seal
^ Always replace

6. O-ring
^ Always replace

7. Chain tensioner
8. Washer
9. 12 Nm
10. 40 Nm
11. Stop
^ For torque support

12. 28 Nm
13. Torque support
14. Oil pan (upper part)

15. 45 Nm
16. M7 = 16 Nm, M8 = 22 Nm
17. O-ring
^ Always replace

18. Dual-mass flywheel or drive plate
19. Special bolt
^ Always replace

20. Needle bearing
^ Not for automatic transmission 01V
^ For automatic transmission 01V, a centering bushing is bolted into crankshaft instead of needle bearing Go to Fig. 1

21. 10 Nm
22. Sealing flange rear with oil seal
^ To install, slide guide sleeve from kit onto crankshaft

23. Cylinder block
24. 20 Nm
25. Guide tube for oil dipstick
26. Sheet metal screw
27. Gasket
^ Always replace

28. Sealing flange, front





Fig. 1 Centering bushing of drive plate for automatic transmission 01V

For vehicles with an automatic transmission, the drive plate is bolted to the crankshaft with a centering bushing (arrow).