Measured Value Block, Reading

Measured Value Block, Reading

Requirements
- Coolant temperature at least 80 degrees C.
- Electrical devices switched off (coolant fan must not run during test).
- Air conditioning switched off.

Work sequence
- Connect vehicle diagnostic, testing and information system VAS 5051 and select vehicle system "01 - Engine electronics" in selection. Engine must be run at idle.







Display on VAS 5051:
- Under -1- select diagnostic function "08 - Read measured value block".







Display on VAS 5051:
1. Enter display group

- Enter desired display group number (three figures) in zone -2- and confirm entry by pressing -Q- button.

NOTE: The choice of display group depends on the particular functions and components to be tested.







Display on VAS 5051:
1. Display group X
2. Display zone 1
Display zone 2
Display zone 3
Display zone 4
3. Display group X

NOTE:
- If no display follows, a display field is not assigned.
- To switch to a different display group, proceed as follows:

Display group VAS 5051 tester
Higher Press Up arrow button.
Lower Press Down arrow button.

- Press square button to end function "08 - Read measuring value block".