Power Distribution Module: Service and Repair

Vehicle Electrical System Control Module J519, Removing And Installing

NOTE: Should Vehicle Electrical System Control Module J519 require replacement, follow replacement procedures as specified using VAS 5051/5052 in mode "Guided Fault Finding".

Removing

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

- Where applicable, remove drivers storage compartment.







- Remove nuts - arrows - and remove Vehicle Electrical System Control Module J519 -1-.







- Unclip fuse carriers -1... 3 -.
- Release retaining clip at connector - 4 - and disconnect connector.
- Disconnect electrical connections - 5 - and - 6 -.

Installing
Install in reverse order of removal, noting the following:
- Install drivers storage compartment.

Tightening torque

Component - fastener Nm
Control module to central tube 2.4
for instrument panel - nut