ATF Lines, Removing and Installing (Overview)

ATF lines, removing and installing (overview), 01V, 5 SPD. A/T AWD

Special tools and equipment

VAG 1306 drip tray:

ATF lines, removing and installing, (vehicles with 4 cyl. engine)





Notes:
^ Place V.A.G 1306 drip tray underneath.

1 - Bolt (21 Nm)
^ Insert line until impact by hand before tightening

2 - Oil line to cooler
^ Note marking on transmission housing

3 - Oil line from cooler
^ Note marking on transmission housing

4 - O-ring
^ Apply ATF when inserting
^ Always replace

5 - O-ring
^ Apply ATF when inserting
^ Always replace





6 - Bolt (5 Nm)
^ Insert line until impact by hand before tightening

7 - O-ring
^ Apply ATF when inserting
^ Always replace

8 - Bolt (5 Nm)
^ Insert line until impact by hand before tightening

9 - Union nut - 29 Nm
10 - Bracket
11 - Hex bolt
^ does not need to be removed when removing and installing ATF lines

12 - Nut - 5 Nm
13 - Clamp
14 - Bracket
^ on engine/transmission support