Selector Shaft, Disassembling and Assembling

Selector shaft, disassembling and assembling, 01E, 6 Spd. M/T AWD





1 - Selector cylinder
2 - Spring pin
^ Removing and driving in flush go to Fig. 1
^ Installation position of spring sleeve: Slot longitudinal to line of force

3 - Selector shaft
^ Tapping out go to Fig. 2
^ Tapping in go to Fig. 3
^ Installation position: Flat (arrow) and selector finger -item 4- face in same direction

4 - Selector finger
^ Observe installation position to -item 3-

5 - Toggle for reversing light switch





Fig. 1 Removing and installing spring pin flush
A - Drift
B - Vice clamps





Fig. 2 Driving out selector shaft
A - Drift
B - Vice clamps





Fig. 3 Driving in selector shaft
A - Wooden packing

Notes:
^ Bring selector shaft/selector cylinder bores into alignment.
^ Flat on selector shaft and selector finger point in same direction.