Conventional Clutch

Conventional clutch, servicing, 02X, 6 Spd. M/T AWD





1 - Flywheel/dual mass flywheel

2 - Bolt for flywheel
^ Always replace
^ Bolt length: 22.5 mm; 60 Nm plus an additional 90° 1/4 turn
^ Bolt length: 43 mm; 60 Nm plus an additional 180° 1/2 turn

3 - Clutch plate
^ Installation position: Clutch lining must make full contact with flywheel
^ Marking Getriebeseite (transmission side), if provided, faces pressure plate/transmission.
^ Coil springs (damper assembly) point toward pressure plate and transmission

4 - Pressure plate

5 - Bolt - 22 Nm
^ Loosen and tighten gradually in several stages and in diagonal sequence






- Loosen and tighten bolts gradually in several stages and in diagonal sequence.
- To remove, reverse position of counter-hold tool 3067 or counter-hold tool 10 - 201.