Clutch System, Bleeding

Clutch system, bleeding, 01E, 6 Spd. M/T AWD

Special tools, testers and auxiliary equipment required

VAS 5234 Brake filler and bleeder unit:

- Brake fluid specification.

Notes:
^ Open the bleeder valve before switching on the bleeder unit.
^ When performing the following steps, make sure that no brake fluid escapes onto the transmission.
^ The clutch system must be bled after performing work on the hydraulic clutch mechanism.
^ Before bleeding, pull out clutch pedal and fill brake fluid reservoir with brake fluid up to "maximum." marking.

- Connect VAS 5234 Brake filler and bleeder unit, but do not switch on at this stage.
- If installed, remove noise insulation beneath transmission.





- Connect bleeder hose -A- to slave cylinder (arrow) and open bleeder valve.
- Connect bleeder hose to pressure hose of fluid collector bottle.
- Switch on the bleeder appliance and allow about 100 cm3 of brake fluid to drain out.
^ Working pressure 2.5 bar

Note: Ensure bleeder hose is correctly installed during bleeding operation.

- Close bleeder valve and tighten to 4.5 Nm.
- Depress clutch pedal several times after completion of bleeding process.
- Bleed again if necessary.