Self-Adjusting Clutch (Sachs Version)

Self-adjusting clutch (Sachs version), servicing, 02X, 6 Spd. M/T AWD

CAUTION: On this type of clutch the pressure plate and clutch plate can only be replaced together.






1 - Bolt - 22 Nm

2 - Pressure plate

3 - Clutch plate
^ Installation position: Clutch lining must make full contact with flywheel
^ The marking Getriebeseite (transmission side), if provided, faces pressure plate/transmission.
^ If installed, coil springs (damper assembly) face pressure plate and transmission

4 - Bolt for flywheel
^ Always replace

^ Bolt length: 22.5 mm; 60 Nm plus an additional 90° 1/4 turn
^ Bolt length: 43 mm; 60 Nm plus an additional 180° 1/2 turn

5 - Dual-mass flywheel
^ Observe instructions for removal

Removing dual-mass flywheel

Note:
^ Do not use an impact wrench or pneumatic wrench to remove bolts - B -: this would severely damage the dual-mass flywheel. Bolts - B - must always be removed by hand.

- Rotate flywheel - A - so that bolts - B - are aligned centrally behind the holes - arrows
- When removing bolts - B -, make sure the bolt heads do not contact the flywheel - arrows - because this would damage the flywheel when the bolts are turned further.