Front Final Drive, Servicing

Front final drive, servicing, 01V, 5 Spd. A/T AWD





^ Transmission installed

Notes:
^ General repair notes
^ Rules of cleanliness for working on automatic transmissions.

1 - Seal
^ Between final drive and transmission housing
^ Always replace

2 - Adjustment shim
^ Behind tapered roller bearing outer race

3 - Tapered roller bearing outer race
4 - Locking screw - 30 Nm
^ With seal
^ Always replace





5 - Bolt - 23 Nm
6 - Right drive flange
7 - Right drive flange seal
^ Always replace

8 - Bolt - 23 Nm
^ Observe tightening sequence

9 - Cover for final drive
10 - Adjustment shim
^ Behind tapered roller bearing outer race

11 - Tapered roller bearing outer race
12 - O-ring
^ Always replace

13 - Differential





14 - Bolt - 23 Nm
^ Observe tightening sequence

15 - Cover for front final drive
^ Front wheel drive version shown
^ All Wheel Drive (AWD) version

16 - Bushing
17 - Gasket
^ Always replace

18 - Spring dowel sleeve
19 - Lever
^ For shift rod

20 - Seal
^ For shift rod
^ Always replace

21 - Bolt - 23 Nm





22 - Left drive flange seal
^ Always replace

23 - Drive gear
^ For speedometer Vehicle Speed Sensor (VSS) -G22-
^ Installation position

24 - Left drive flange
^ Removing and installing

25 - Mounting bracket for drive flange
26 - Grooved ball bearing for drive flange
^ Always replace

27 - Snap ring
28 - O-ring
^ Square cross section
^ Remove and install left drive flange to replace