Technician Safety Information

Safety precautions

CAUTION: Fuel system is under high pressure! Before opening high pressure components of the fuel injection system, pressure must be relieved to residual pressure Procedure that must be performed before opening the high-pressure fuel injection system. Pay close attention! Then wrap a clean rag around the connection and relieve residual pressure by carefully loosening the connection.

To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:
^ The ignition must be switched off before connecting or disconnecting injection and ignition system wiring or tester cables.
^ It is possible that the control module will recognize a malfunction and store a DTC during some tests. Therefore, when all tests and repairs are completed, the DTC memory must be checked and, if necessary, erased. After DTC memory is erased, a readiness code must be generated for the engine control module using operating mode Guided Fault-finding.
^ Cleaning the engine should only be performed with ignition switched off.

CAUTION:
^ The battery must only be disconnected and connected with the ignition switched off, since the Engine Control Module (ECM) can otherwise be damaged.
^ Observe procedures for disconnecting battery.