Fuel System, Bleeding

Fuel System, Bleeding

To prevent damage to catalytic converter the fuel system must be bled after repair work on fuel lines or on fuel filter.

Work procedure
- Start engine and let engine run a few minutes at average RPM and then turn off again.

NOTE: At the beginning, engine may run roughly due to air in fuel supply system.

- Check fuel supply system for leaks.
- Check DTC memory and, if necessary, erase.
- Perform a road test with at least one acceleration at Wide Open Throttle (WOT), then fuel supply system must be checked again for leaks.
- Check DTC memory and, if necessary, erased. After DTC memory is erased, a readiness code must be generated for engine control module using operating mode "Guided Fault-Finding".