4-Way Relay Carrier In Electronics Box In Plenum Chamber, Removing and Installing

4-way Relay Carrier In Electronics Box In Plenum Chamber, Removing And Installing

Removing

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.







- Remove rubber seal of plenum chamber cover in direction of - arrow -.
- Remove plenum chamber cover - 1 - to front.







- Use screwdriver to pry off the two caps - 3 -.
- Loosen nuts - 4 - (do not remove).
- Remove wiper arms - 2 - from wiper shaft by tilting slightly.
- Remove nuts completely and remove wiper arms.
- Pull off retaining clips - 1 - and detach cowl panel grille - 5 -.







- Remove cover for electronics box in plenum chamber - arrows -.







- Use screwdriver to pry off retaining strap - arrows -.
- Lay aside engine control module with wires attached.
- Where applicable, release the retaining clip for the transmission control module.
- Lay aside transmission control module with wires attached.







- Release retaining clips - arrows - and lift auxiliary relay carrier out of electronics box.
- Unclip the fuse carriers at the 4-position relay carrier.
- Remove relays and control modules and then unclip appropriate relay carrier.







NOTE: Refer to the applicable wiring diagram for exact identification of connections on electronics box Wiring Diagrams

Installing
Install in reverse order of removal.