9-Position Relay Carrier, Removing and Installing

9-position Relay Carrier, Removing And Installing

Removing

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

- Where applicable, remove drivers storage compartment.







- Remove nuts - 3 - remove Vehicle Electrical System Control Module J519 with wires attached.
- Remove 9-position relay carrier - 4 -.

NOTE: Disregard - 1 - and - 2 -.

- Unclip the fuse carriers at the 9-position relay carrier.
- Remove relays and control modules and then unclip appropriate relay carrier.







NOTE: Refer to the applicable wiring diagram for exact identification of connections on relay carrier Wiring Diagrams.

Installing
Install in reverse order of removal, noting the following:
- Install drivers storage compartment.

Tightening torque

Component - fastener Nm
9-position relay carrier to central 2.4
tube for instrument panel - nut