ATF, Changing or Topping Off After Repairs

ATF, changing or topping off after repairs, 01V, 5 SPD. A/T AWD

Special tools and equipment

VAG1306 drip tray:

VAG1924 ATF filler tool:

^ Engine switched off.





- Secure container of V.A.G 1924 ATF filler tool as high up on vehicle as possible.
- Raise vehicle.





- Remove noise insulation panel (arrows).

Notes:
^ Observe disposal regulations.
^ Engine must not be started without ATF and vehicle must not be towed!

- Place V.A.G 1306 drip tray under transmission.





- Remove drain plug (arrow -1-).
- Let ATF drain.
- Tighten new drain plug (arrow -1-) to 40 Nm.

Note: Drain plug and oil seal must both be replaced.

- Remove ATF check plug (arrow -2-).





- Insert V.A.G 1924 ATF filler tool into an opening (arrow) in the protective cap, but do not knock cap upward.





- Fill with ATF using V.A.G 1924 ATF filler tool until ATF exits from the check hole.
- Shift selector lever into position "P".
- Start engine.
- Keeping the brake pedal depressed, shift into all selector lever positions at idle speed. Each position must remain selected for at least 10 seconds.
- Shift selector lever into position "P".
- Check ATF level and top off.
- Install noise insulation.

Note: Observe all notes and test requirements for Checking ATF level.