Recommended Sequence For Adjusting Gear Set

Recommended sequence for adjusting gear set, 02X, 6 Spd. M/T AWD





The following work sequence is recommended to save time when the ring gear and pinion shaft have to be adjusted:
^ Determine total shim thickness "Stotal" (S3 Plus S4) for the specified preload on pinion shaft tapered roller bearings.
^ Distribute total shim thickness "Stotal" (S3 Plus S4) So that dimension from center of ring gear to end face of pinion shaft corresponds to installation dimension "R" determined during production.
^ Determine total shim thickness "Stotal" (S1 Plus S2) for the specified preload on differential tapered roller bearings.
^ Distribute total shim thickness "Stotal" (S1 Plus S2) so that the specified backlash between ring gear and pinion shaft is obtained.