Component Overview

Component overview, 01E, 6 Spd. M/T AWD





Part 1

Note: Lubricate bearing areas and slide surfaces with polycarbamide grease, Part No. G 052 142 A2.

1 - Ball
2 - Rubber ring
3 - Ball guide
4 - Rubber ring
5 - Washer
^ Shoulder faces ball guide (item 3)

6 - Snap ring
^ Remove to remove the ball





7 - Compression spring
8 - Spacer bushing
9 - Washer
10 - Snap ring
11 - Noise insulation cover
12 - Shift knob
^ With cover
^ Removing and installing

13 - Nut - 10 Nm
14 - Ball housing
15 - Inner Torx bolt





16 - Shift lever
^ Angled area faces rear

17 - Bolt
18 - Nut - 10 Nm
19 - Shift mechanism housing
20 - Shift fork
21 - Nut - 10 Nm
^ Self-locking
^ Always replace

22 - Bushing





Part 2
1 - Ball socket
^ To remove, bend back peenings on shift rod -item 19-

2 - Washer
3 - Ball socket
^ To remove, remove locking clips -item 9-

4 - Boot
5 - Transmission shift lever
6 - Nut - 23 Nm
7 - Bolt - 23 Nm
8 - Operating rod
^ To remove, remove locking clips -item 9-





9 - Locking clamp
10 - Bolt - 40 Nm
11 - Pivot rod
^ with bushing, bolt and washers

12 - Socket head bolt - 23 Nm

13 - Washer
14 - Ball housing
15 - Tensioning ring
16 - Boot
^ Carefully pull over shift rods when removing
^ When installing, place on markings of shift rod and pivot rod





17 - Socket head bolt- 23 Nm
18 - Clamping piece
19 - Shift rod
20 - Shift fork
21 - Nut - 10 Nm
22 - Nipple