Trigger Wheel For Speedometer Vehicle Speed Sensor -G22-, Removing and Installing

Trigger wheel for speedometer vehicle speed sensor -G22-, removing and installing, 01E, 6 Spd. M/T AWD

Special tools and workshop equipment required

VW 681 Seal extractor:

2062 Fitting drift:

- Container

Removing
^ Transmission installed

- Partially remove front part of exhaust system.
- Remove shield, if installed, from underneath transmission.





- If installed, remove splash plate above left drive axle -1- (arrows).
- Unbolt drive axle from flanged shaft.
- Place drip tray underneath transmission.





- Remove fastening screw -A- for flanged shaft -B-.
- Pull out flanged shaft.
- Pull out flanged shaft seal -C- with VW 681.
- Remove speedometer vehicle speed sensor.
Remove speedometer trigger wheel -D-:
- Lever out the trigger wheel from the grooves in the differential at the drive pegs -arrows- on alternate sides.

Installing
Installation is carried out in the reverse order to removal, noting the following:
Installation position:





The drive pegs -arrows- of the trigger wheel -D- must engage in the grooves of the differential.
- Drive in seal -C- for flanged shaft and install flanged shaft.

Tightening Torque: