Diagnostic Mode 01: Obtain Data

Diagnostic Mode 01: Obtain Data

Diagnostic Mode 01 is used to display and monitor all emissions related measured values.

Test requirement
- Coolant temperature at least 80 degrees C.

Procedure
- Connect the diagnostic tester.
- Start the engine and run at idle.
- Select "Diagnostic Mode 1: Obtain data.".
- From the following table, select the desired the "PID" that is to be monitored, e.g. "PID 05-Coolant temperature".

NOTE: More than one "PID" may be selected and monitored.

The current values of the component or system that is being monitored will be displayed on the diagnostic tester screen.

PID Display measuring values

01: Monitoring status since erasing DTC memory
03: Condition of fuel system
04: Calculated load condition value
05: Coolant temperature
06: Short term gasoline-air ratio bank 1
07: Gasoline-air ratio bank 1
12: Engine rotations per minute (RPM)
13: Vehicle speed
14: Ignition timing adjustment at 1. cyl. in direction
15: Intake air temperature (IAT)
16: Air flow quantity at Mass Air Flow (MAF) sensor
17: Throttle valve position (absolute)
19: Existing oxygen B1 to B2-S2 to (exist./nonexist.)
21: Bank 1 - sensor 2
28: OBD request is designed for diagnostic of this vehicle
31: Time after engine on
33: Driven distance after MIL on
35: Fuel Rail Pressure
46: Commanded Evaporative Purge
48: Number of warm ups since diagnostic trouble codes
49: Distance since diagnostic trouble codes cleared
51: Barometric Pressure
52: Bank 1 - sensor 1
56: Bank 2- sensor 1
60: Catalyst Temperature Bank 1, Sensor 1
65: Monitor status this driving cycle
66: Control module voltage
67: Absolute Load Value
68: Commanded Equivalence Ratio
69: Relative Throttle Position
70: Ambient air temperature
71: Absolute Throttle Position B
73: Accelerator Pedal Position D
74: Accelerator Pedal Position E
76: Commanded Throttle Actuator Control

- Switch the ignition off.
- End of diagnosis.