VAS 5051 Vehicle Diagnosis, Measurement and Information System, Connecting and Selecting Functions

VAS 5051 Vehicle Diagnosis, Measurement and Information System, connecting and selecting functions, 01J CVT A/T FWD

Test requirements
^ Parking brake applied.
^ Vehicle voltage supply O.K.
^ Voltage supply and fuses for particular system O.K.
^ Ground connections for transmission O.K.
- Check ground connections for corrosion and damaged connection, repair as needed.
- Check battery ground (GND) strap and ground (GND) strap between battery and transmission.

Test procedure
- Switch ignition OFF.





- Connect VAS 5051 Vehicle Diagnosis, Measurement and Information System with diagnostic lead VAS 5051/1.

Note: The Data Link Connector (DLC) is located at the left-side knee bolster.

CAUTION: Please observe safety precautions.

Note: If an error message appears in the display go to Users Manual for VAS 5051 Vehicle Diagnosis, Measurement and Information System VAS 5051





Display on VAS 5051
- Touch "Vehicle OBD" button.





Display on VAS 5051

Note: By touching "00 Read DTC Memory Complete System" in the selection - 1 - the automatic test sequence is performed, i.e. a scan is performed of the DTC memory for aft systems in the vehicle capable of OBD.

Depending on the desired function:
- Switch ignition ON.

or
- Start engine.
- In selection -1- touch vehicle system 02 Transmission Electronics.
- Wait until next display appears on screen.





Display on VAS 5051:
1 - Control module identification number of the Transmission Control Module (TCM)

Identification number of Transmission Control Module (example):