Clutch Switch: Service and Repair
Clutch pedal switch F36, removing and installing, 01X, 6 Spd. M/T FWD
Note:
^ Clutch pedal switch F36 may only be installed once so as to ensure a firm fit.
Removing
- Remove storage compartment on drivers side.
- Disconnect electrical connector -1- on clutch pedal switch.
^ The clutch pedal -3- is in the normal position (i.e. not pressed down). The operating rod - arrow - of the clutch pedal switch F36 should then rest against the clutch pedal.
- Release clutch pedal switch F36 -2- by turning 45° counter-clockwise and remove from guide.
Installing
Installation is perform in reverse sequence. Note the following:
- Pull out operating rod -arrow- all the way before installing clutch pedal switch F36.
^ The clutch pedal should be in the normal position (i.e. not pressed down).
- Guide clutch pedal switch F36 through mounting hole, press against clutch pedal and attach by turning 45° clockwise.
- Plug in connector for clutch pedal switch F36.
- Install storage compartment on drivers side.
Removing and installing clutch pedal starter interlock switch F194
Note:
- To ensure a secure fit, the clutch pedal starter interlock switch F194 must not be installed more than once.
Removing
- Remove storage compartment on drivers side.
- Disconnect electrical connector -3- on clutch pedal starter interlock switch.
- Press clutch pedal -1- all the way down and hold it in this position.
- At the same time, release clutch pedal starter interlock switch -2- by turning it 45° in the direction indicated -arrow- and pull it out of the guide.
Installing
- Pull out operating rod -arrow- all the way before installing clutch pedal switch.
- When installing clutch pedal starter interlock switch, press clutch pedal -1- all the way down -arrowA-. Hold clutch pedal in this position.
- Guide clutch pedal starter interlock switch -2- through opening in retainer, and at the same time push operating rod against clutch pedal and secure switch by turning it 45° in the direction indicated - arrowB-.
- Connect electrical connector -3- on clutch pedal starter interlock switch.
- Install storage compartment on drivers side.