Body Control Systems: Locations

Central Locking System

Component overview, Sedan







1. Right front door control module J387
- Integrated in window regulator.
2. Right Rear Door Control Module J389
- Integrated in window regulator.
3. Motor for fuel tank lid release V155
- Removal
4. Central control module for comfort system J393
- Component location, in right rear side panel.
5. Motor for rear lid release V139
6. Left Rear Door Control Module J388
- Integrated in window regulator.
7. Driver's Door Control Module J386
- Integrated in window regulator.
8. Front hood switch F266
- Component location in lock carrier

Component overview, Avant







1. Front Passenger s Door Control Module J387
2. Right Rear Door Control Module J389
3. Motor for fuel tank lid release V155
- Removal
4. Central control module for comfort system J393
- Component location, in right rear side panel.
5. Motor for rear lid release V139
6. Rear Lid Control Module J605
7. Left Rear Window Shade Control Module J765
8. Left Rear Door Control Module J388
9. Drivers Door Control Module J386
10. Front hood switch F266
- Component location in lock carrier







Front door control module installation position
- To install, insert door control module - 1 - in lower mounting points, swing upward and engage.
- Window regulator motor - 2 -.







Rear door control module installation position
- To install, insert door control module - 1 - in lower mounting points, swing upward and engage.

Remove Fuel Tank Lid Unlock Motor - V155 -

Special tools, testers and auxiliary items required







- Socket wrench T10010.







1. Motor for fuel tank lid release
- Side trim on right side of luggage compartment removed.

- Disconnect electrical harness connector to motor.
- Loosen bolts - arrow - turning toward right using socket wrench T10010 and slide motor - 1 - out of oblong holes.
- Before installing new motor, you must first slide emergency release eye - 4 - over locking pin.

NOTE:
- For easier installation, slide an appropriate hose - 5 - from outside to inside as an assisting tool in luggage compartment.
- Place hose - 5 - on operating rod - 4 - and pull outward in tank cup.

- Slide motor into oblong holes and tighten screws to 2 Nm by turning to left

2. Securing clip
3. Operating rod
4. Cable for emergency release
- Window regulator motor - 2 -.