2-pin relay and fuse panel behind instrument panel, driver's side, removing and installing

2-pin relay and fuse panel behind instrument panel, driver's side, removing and installing

Removing





- With ignition switched off, disconnect battery Ground (ND) wire => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove lower instrument panel cover on driver's side.

- Remove screws - arrows -.

- Remove relay and fuse panel - 1 -.

If necessary, proceed with work steps.

- Unclip fuse panel at relay and fuse panel.

- Disconnect relays and unclip respective relay carrier.

• For the exact assignment of the 2-pin relay and fuse panel behind instrument panel on driver's side, refer to the current wiring diagram.

Installing

Install in reverse order of removal, observing the following:

- Install lower instrument panel cover on driver's side.

- Connect battery. Required actions => [ Vehicles with : ] Battery, Disconnecting and Connecting.

Tightening Specifications