Center Rear Three-Point Seat Belt with Folding Backrest
Center Rear Three-Point Seat Belt with Folding Backrest
Special tools, testers and auxiliary items required
• torque wrench (V.A.G 1332)
1 Seat Belt Anchor
2 Belt Webbing
3 Belt Relay
4 Bolt
• Tightening specification 55 Nm
5 Anti-rotation Protector
6 Tube
7 Adapter Plate
8 Third Rear Three-Point Seat Belt
• Removing
- Remove the rear bench seat. Refer to => [ Bench Seat ] Bench Seat.
- Remove seat belt anchor - 1 - => [ Remove belt anchor ].
- Remove 2/3 rear seat backrest. Refer to => [ Right 2/3 Backrest ] Right 2/3 Backrest.
- Remove 2/3 rear seat backrest upholstery until you can remove anchor with upholstery.
- Remove the screw - 4 -.
- Vehicles with a seat belt tensioner: open the catch - 15 - and disconnect the connector - 9 -.
- Remove nut - 10 -.
- Remove seat belt - 8 -.
• Installing
Installation is in reverse order of removal. Be sure to note the following:
- Place an adapter plate - 7 - in anti-rotation protector - 5 - if needed.
- Insert seat belt - 8 -.
- Ensure seat belt is seated correctly on anti-rotation protector - 5 - or adapter plate - 7 -.
- Install nut - 10 - and tighten lightly by hand.
- Align the seat belt - 8 -: the horizontal edges on the frame must be parallel to tube - 6 -.
- Tighten the nuts - 10 -. Hold seat belt in aligned position by counterholding with screwdriver.
- Vehicles with a seat belt tensioner: make sure the connector - 9 - is secure and then close the bracket - 15 -.
- Clip belt guide cover in by hand - 12 -.
- Ensure retainer tabs - 11 - (quantity: 2) engage in body.
- Vehicles with a seat belt tensioner: check the safety belt fastening detection. Refer to => [ Rear Three Point Seat Belt with Belt Tensioner, Checking Belt Fastening Detection ] Seat Belts, Inspecting.
• The belt relay - 3 - and belt webbing - 2 - must not touch or graze foam pieces or anchor pieces.
• Belt relay - 3 - must follow each belt webbing movement.
• Belt webbing - 2 - must move freely in all directions.
9 Belt Tensioner Connector
10 Nut
• Tightening specification 55 Nm
11 Retainer Tabs
Quantity: 2
12 Belt Guide Cover
13 Sealing Ring
• Must be replaced
14 Bolt
• Tightening specification 55 Nm
• Use only original screws
15 Securing Bracket
Remove belt anchor
• Removing
- Remove the screw - 1 -.
- Slide belt anchor - 4 - out in direction of arrow.
- Thread belt webbing - 2 - out of guide - 3 -.
- Loosen belt anchor by loosening seal from screw on underside and removing screw.
• Installing
Installation is in reverse order of removal. Be sure to note the following:
• Tightening specification for the bolt - 1 -: 55 Nm.