Indirect Ventilation Trim

Instrument Panel

Indirect Ventilation Trim

Removing





- Unclip cover cap - 1 - using a feeler gauge 0.35 mm - 2 - out of center defroster vent - arrow -.

- Pry out Sunlight Photo Sensor (G107) - item 3 - and disconnect harness connector.

- Remove bolt - 1 -.





- As depicted in the illustration, pry center defroster vent - 2 - out of instrument panel using trim removal wedge (3409).

- Remove the bolts - 2 -.





- Remove panel for indirect ventilation - 1 -.

Installing





Installation is reverse of removal, noting the following:

- Make sure that clips - 3 - engage into instrument panel mounts.

Tightening torque:

Panel for indirect ventilation to instrument panel: 2 Nm