Adjusting Panel

Adjusting Panel

• Height adjustment test is performed in the sliding position, meaning the panel is slid open and not tilted open.

• To achieve the best possible exterior optical characteristics, make sure that the adjustments on left and right sides are performed as symmetrically as possible.

• Measuring points for this are the radial runouts on the panel.

• Sunroof panel must not be higher than roof at any point at front or lower than roof at any point at rear.

- Remove trim plate starting at front and working toward rear.

- Pull off trim plate completely toward vehicle interior and fold it away downward.

- Loosen Torx bolts for mounting panel.

- Center the panel by dipping through several times.

- Position panel at front and rear as shown in the illustration.





- Drive sunroof closed from "opened" position (not tilted open).

- Measuring points are radial runouts on sunroof panel.

- Dimension - a - = 0 -1mm.

- Dimension - b - = 0+1mm.

- - arrow - = direction of travel

- Tighten Torx bolts to 4.5 Nm.





- Install side trim plates.