HID Lamp Control Module

HID Headlamps

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

• Adjust the headlamps after performing any work that could have affected their adjustment.

HID Lamp Control Module

Removing






Danger to life due to high voltage.

• Observe usage and safety information for gas discharge headlamps.

- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove headlamp. Refer to => [ Headlamps ]. Headlamps

- Remove bolts - arrows - and remove control module from headlamp housing.

- Unplug connector.

Installing

Install in reverse order of removal, observing the following:

- Check seal between High-intensity Gas Discharge Lamp Control Module and headlamp housing.

- Install headlamp. Refer to => [ Headlamps ]. Headlamps

- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.

Tightening Specifications