Vehicle Alignment, Bringing into Center Position

Vehicle Alignment, Bringing into Center Position

Suspension Alignment Control Position, Checking

- Connect the (VAS 5051A) and select the function test using "Functions/Component selection". Refer to => [ VAS 5051, Connecting and Selecting Functions ] Level Control System.

Then

- "J197 - Level control system control module functions".

- "44 - Wheels, tires, vehicle alignment".

- "KD44 85 - Axle alignment".

• Activate vehicle lift mode only after checking or reprogramming height dimensions.

- Activate vehicle lift mode. Refer to => [ Vehicle Lift Mode ] General Information.

1BK Suspension

- Front height dimension: 416 mm

- Rear height dimension: 398 mm

2MA and 2MB Suspension

- Front height dimension: 396 mm

- Rear height dimension: 378 mm

Height Dimension - x -, Determining

Height dimension - x - is the measurement in mm between the center of the wheel and the lower edge of the fender.

- Measure the wheel diameter.





The measured value gives dimension: - a -.

- Measure from the upper wheel edge vertically to the lower fender edge.

The measured value gives dimension: - b -.

Height dimension x is derived from:

x = a : 2 + b.