Fuel Pump: Locations

Fuel tank with attachments, component overview





1. Securing strap
^ With spacer, installed location

2. 22 Nm
3. Fuel supply line
^ From fuel filter
^ To fuel rail
^ To disconnect, press release tab on connection piece

4. Fuel return line
^ From engine
^ To disconnect, press release tab on connection piece
^ Clip in on fuel tank

5. Vent pipe
6. Ground connection
^ To eliminate electrostatic charge
^ Installed position / check requirements
^ Make sure the connector is seated securely.
^ After installation, use an ohmmeter to check the electrical connection of the fuel filler tube on a bare metal part on the body. Specification: approximately 0 ohms

7. Cap
8. Oil seal
^ Replace if damaged

9. 22 Nm
10. Electrical harness connector
^ For fuel tank lock switch

11. Vent pipe
^ To evaporative emissions (EVAP) canister in spare wheel well on vehicle floor
^ Remains on fuel tank when fuel tank is removed

12. Fuel tank
13. Bushing
14. Bracket
^ For fuel tank

15. 22 Nm
16. Rubber buffer
17. Washer
18. 22 Nm
19. 22 Nm
20. Securing strap
^ With spacer, installed location

21. Retaining clip
^ For heat shield

22. Heat shield
23. Retaining clip
^ For heat shield





Installed location of spacer
- Make sure that the spacer of the securing strap is seated directly below the seam of the fuel tank - arrow -.





Installation position of Ground (GND) connection
- Route Ground (GND) connection as shown in illustration.
- Make sure the Ground (GND) connector connection seats securely at metal ring of fuel filler tube - arrow -.

CAUTION: After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body:
^ Specification: approximately 0 ohms.