Access/Start Authorization Switch E415, Removing and Installing

Access/Start Authorization Switch E415, Removing And Installing

NOTE:
- Adaptation is not necessary if only Access/Start Authorization Switch E415 is replaced.
- Adaptation must be performed if keys are replaced in addition to Access/Start Authorization Switch E415.

Special tools, testers and auxiliary items required







- Socket tool T10152







Removing
- Switch off ignition and remove ignition key.
- Remove drivers storage compartment Body Interior
- Use small screwdriver to pry off trim ring at Access/Start Authorization Switch - arrow - .







- Unscrew nut at Access/Start Authorization Switch E415 using Socket tool T10152.
- Take switch to rear out of drivers storage compartment.







Installing
Install in reverse order of removal, observing the following:
- Observe installation position of Access/Start Authorization Switch E415 with respect to drivers storage compartment.
- Lug - 1 - facing upwards
- Hand-tighten nut using Socket tool T10152.
- Observe installation position of trim ring at Access/Start Authorization Switch.
- Lugs - 3 - must engage in recesses - 2 - at switch.
- Install drivers storage compartment.