Procedures

Level control system control module -J197-, removing and installing

Removing
- If the control module is to be replaced, in the "Guided fault-finding" select the "Replace" function of the relevant control module.

Use vehicle diagnostic, testing and information system VAS 5051 for this purpose.

Note: The level control system control module -J197- is installed behind the glove box on the bulkhead.

- Removing glove compartment.
- Remove air duct in front of control unit.





- Release the connector -1- from the control module in the direction of the arrow and detach.
- Remove control unit -2-.

Installing
Installation is in reverse order. Note the following:
- Perform the adaptation procedure for level control system control module -J197-.