Suspension: Locations

Engine wiring, routing on engine





1. Heat insulation sleeve
^ Attach to Camshaft Position (CMP) sensor 4 -G301-

2. Electrical harnesses for camshaft adjusters
^ Clip into retainers

3. Cable tie with clip
^ Clip into hole of bracket

4. Retaining clip
^ Tighten to 9 Nm

5. Ground wire
^ Tighten to 9 Nm

6. Cable tie for oxygen sensor harnesses
^ Fasten to wiring to ignition coils cyl. 1 to 3 and cyl. 4 to 6

7. Cable tie for oxygen sensor harnesses
^ Clip into hole of bracket

8. Retaining clip
^ Tighten to 9 Nm

9. Electrical harnesses for camshaft adjusters
^ Clip into retainers

10. Heat insulation sleeve
^ Attach to Camshaft Position (CMP) sensor 3 -G300-

11. Harness clip
^ Clip into holes

12. Ground wire
^ Tighten to 9 Nm