Basic Setting (Allroad), Performing

Basic setting (Allroad), performing
Basic setting must be performed if the level control sensor, the entire unit or the control module is replaced.
^ Perform basic setting.
Determining height dimension: -x-
The height dimension -x- is the value in mm between wheel center and lower edge of fender.





^ Measure rim diameter.
Measure value determines dimension: -a-
^ Measure vertically from upper edge of rim to lower edge of fender
Measure value determines dimension: -b-
Height dimension -x- results from:
-x- = -a- / 2 + -b-





^ After performing basic setting, check whether height dimension -x- = 402mm ± 5 mm. If this is not the case, repeat basic setting.
^ After performing basic setting, check whether height difference between left and right side is not larger than ± 4 mm. If this is not the case, repeat basic setting.