For Transmissions With Hydraulic Control E17

Read Measuring Value Block (scan tool function 08)

Notes: There is a distinction made between two types of transmission.
^ 1. Transmissions with hydraulic control E17, the sensor for transmission RPM (inductive sensor) is secured to bottom of valve body.
^ 2. Transmissions with hydraulic control E1812, the sensor for transmission RPM (hall effect sensor) is secured to transmission housing behind valve body.

Read measuring value block for transmission with hydraulic control E17.
Read measuring value block for transmission with hydraulic control E1812.

Read Measuring Value Block (scan tool function 08) for transmissions with hydraulic control E17

Notes: For transmissions with hydraulic control E1812, "Read Measuring Value Block".

CAUTION: To avoid risk of accident during measuring and test drives, observe the safety precautions.

Procedure
^ Connect VAS5051 tester or VAG 1551 scan tool and select Transmission Control Module (TCM) using "address word" 02. Ignition must remain switched on for this.





Indicated on display
^ Press PRINT button to turn on Scan Tool (ST) printer. Indicator lamp in button must light up.
^ Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.





When indicated on display:
^ Enter desired display group number =display group overview.
^ Confirm input using the -Q- button.





Indicated on display (example) for display group 001:

Notes:
^ Clarification of values in the individual display fields; Refer to Test table.
^ Display can be printed out on the paper roll when printer is switched on.





^ To switch to a different display group, proceed as follows:
^ If specified values are obtained in all display fields, press-I button.





Indicated on display (function selection):

Display Group 001 - 003:

Display Group 004 - 006:

Display Group 007 - 009 1):

Display Group 009 2) - 011:

Overview of selectable display group numbers for transmission with hydraulic control E17

Notes:
^ When the printer is switched on, the contents of the display will be printed out on the scan tool log.
^If specified values are not obtained in all display fields:

^ Press -> button.





Indicated on display