For Transmissions With Hydraulic Control E18/2

Read Measuring Value Block (scan tool function 08) for transmissions with hydraulic control E18/2

Notes: For transmissions with hydraulic control E17, "Read Measuring Value Block".

CAUTION: To avoid risk of accident during measuring and test drives, not the safety precautions.

Procedure
^ Connect VAS5051 tester or VAG 1551 scan tool and select Transmission Control Module (TCM) using "address word" 02.

Ignition must remain switched on for this.





Indicated on display
^ Press PRINT button to turn on Scan Tool (ST) printer. Indicator lamp in button must light up.
^ Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.





When indicated on display:
^ Enter desired display group number =display group overview.
^ Confirm input using the -Q- button.





Indicated on display (example) for display group 001:
^ Display can be printed out on the paper roll when printer is switched on.





^ To switch to a different display group, proceed as follows:
^ If specified values are obtained in all display fields, press (arrow) button.





Indicated on display (function selection):

Display Group 001 - 004:

Display Group 005 - 008:

Display Group 009 - 125:

Overview of selectable display group numbers for transmission with hydraulic control E18/2

Notes:
^ When the printer is switched on, the contents of the display will be printed out on the scan tool log.
^ If specified values are not obtained in all display fields:

^ Press (arrow) button.





Indicated on display