Centering Holes For Side Impact Moldings

Centering Holes For Side Impact Moldings

Up to Vehicle Identification Number (VIN) 400 000


1. Front Bumper







- Position hole to vehicle outside - arrow B - according to marking on bumper.

Note:
If there is no marking in this position, the long hole (as depicted in illustration) must be manufactured at upper/outer edge, according to the lines on bumper.

- Position hole to vehicle center - arrow A - according to marking on bumper.


Positioning Centering Holes







- Position of long holes is indicated by markings on bumper.

- Long hole must be aligned to dimensions - a - = 8.5 mm and - b - = 15.5 mm as shown.

- If there is no marking in this area, the long hole must be aligned according to the indicated lines on bumper as shown, with upper edge to horizontal line and with outer edge to vertical line.

- Dimension - a - = 8.5 mm

- Dimension - b - = 15.5 mm

Adhering Centering Pins on Side Impact Molding







Note:
Adhesive and centering pin are in delivery casing of side impact molding.

- Remove protective foil from the double-sided adhesive - 3 - and adhere it onto centering pin - 4 -.

- Remove second protective foil and position centering pin onto marking - arrow - on side impact molding.

- Remove protective foils from double-sided adhesive strips - 2 - and press side impact molding - 1 - onto bumper.

Positioning License Plate Mounting Holes.

There are four centering punch marks on license plate area of bumper cover which must be drilled through for securing a license plate ( dimensions 115 x 520 mm).

If centering punch marks are not visible, proceed as follows:

- Determine vertical bisecting line:

Dimension - a - = dimension - a -

- Determine mounting points for license plate symmetrically as follows:

Dimension - x - = 139 mm.
Dimension - y - = 62 mm.