Fuel Tank With Attachments, Assembly Overview - From 11.04

Fuel Tank With Attachments, Assembly Overview







1. Bracket
- For exhaust system
2. Carrier plate
3. Fuel line
- From fuel filter
- To engine
- Do not kink
- To disconnect, press release button on connection piece
4. Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- Do not kink
- To disconnect, press release button on connection piece
- Clipped in on fuel tank
5. 2 Nm
6. Tire protection shield
- For fuel delivery connection
7. 23 Nm
8. Overflow hose
9. Rubber cup
10. Circlip
11. Oil seal
- Replace if damaged
12. Cap
13. Ground (GND) connection
- For discharging electrostatic charge
- Installed position / check requirements
- After installing, check electrical connection of metal ring at fuel filler tube to a bare area of chassis using Ohm meter - Specified value: approx. 0 ohm.
14. Ventilation line
15. Ventilation line
- From gravity valve to EVAP canister
- To remove, press release ring on EVAP canister
16. Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- To remove, press release ring on EVAP canister
- Clipped in on fuel tank
17. Fuel tank
18. Spreader clip
19. 23 Nm
20. Securing strap
21. Heat shield
- For fuel tank
22. 2 Nm
23. 23 Nm







Installation position of Ground (GND) connection
- Route Ground (GND) connection as shown in figure.
- First hook Ground (GND) connection contact - 1 - into securing hole on fuel tank - 5. and then press in spacer bushing - 2
- Make sure connector of Ground (GND) connection - 4. fits securely at metal ring - 3 - of fuel filler tube.

CAUTION: After installing, check electrical connection of metal ring at fuel filler tube to a blank portion of chassis using Ohm meter.

Specification: approx. 0 Ohm.